SABRE "Conical" Truck Bushings Longboard Skateboard 86a 90a 93a 96a Freeride Slide Carve Cone

SABRE

Conical (Cone) bushings

Choose:

86a 90a 93a 96a

1 Pair

2 replacement bushings, enough for one truck. (or the top bushing for two trucks) & 1 flat washer.

Available in:
86A Orange(softest)
90A Red or Purple
93A Green
96A Grey (firmest)

Many riders prefer to use a harder/firmer bushing "deck side" and a softer barrel or conical bushing "road-side", this gives stability but with responsive turning...best of both worlds.

Don't be afraid to mix the colours and shapes around to get the ride you want.

They fit most longboard trucks: Sabre, Randal, Bear, Paris, Roadrider, Mindless, Bennett, etc.

Sizings(approx.):

Conical bushing : 16mm deep x 25mm diameter (18.5mm top diameter)

What Sabre say about them:
If you want lots of turn with minimal resitance, choose Sabre Cone bushings.  A smaller volume of urethane means that these bushings lean and turn a lot more than Barrels or Kingcones, especially at softer duros. 16mm/0.6" tall and 25mm/0.975" at the wide end, they can be run boardside or roadside in all our trucks. Hand poured from our own exclusive formula in the UK